I had built the worm castings harvesting machine based on my own needs which permits me to harvest worm castings from a quality controlled setting every two weeks from 5 gallon buckets.

I start with some rich organic humus and add a special blend of grain and other organic matter as a food source. Within two weeks the half filled 5 gallon bucket is turned over to 8-10 pounds of worm castings less any debris, i.e. wood chips, bark…

The worm castings harvester is framed out of wood using wood screws to enable the system to endure the vibrations when in use.

The source of energy is produced from a $21.00 finish sander purchased at a local home improvement store.

The rest of the information is pretty much explained within the video below.

]]> http://wormcompostingblog.com/worm-harvesters/homemade-worm-castings-harvester/feed/ 16 http://wormcompostingblog.com/worm-harvesters/simple-homemade-multi-screen-worm-harvester/ http://wormcompostingblog.com/worm-harvesters/simple-homemade-multi-screen-worm-harvester/#comments Sat, 02 May 2009 16:15:28 +0000 Bruce http://wormcompostingblog.com/?p=21 When I first started worm composting, I wanted away to separate my worm castings and cocoons form the rest of the vermicompost mix. I read a number of articles for homemade harvesters, however they either were large utilizing multiple screens or very small with just one size screen.

Hence I went to the drawing board to come up with a solution for my own needs. It is actually a simple device that fits and spins manually in an 18 gallon size Rubbermaid bin. The main unit is built from a five gallon plastic kerosene can.

Keep in mind this worm harvester is for the small worm farmer. It works effectively for one to a number of bins, however once you begin to raise worms on a larger scale, you will want to replace this unit.

I used a stainless steel rod however one could use a short ½” copper pipe. I do recommend sliding end caps on the ends of the pipe so as not to cut oneself when working with the worm harvester. I slid the rod or copper pipe through ¾” PVC fittings on both sides of the bin as well as the five gallon can.

The neat part about this worm harvester is that I use a number of bungee cords to hold the screen in place, enabling myself to start with a 1/8″ screen, then a ¼” screen and finally a ½” screen. This enabled me to separate the worm castings, cocoons and small vermicompost particles effectively.

To work the worm harvester, simply place a small amount of worm compost into the bin, close up the screen opening with two bungee cords and spin the harvester one way then the other way. Once completed, open the screen, remove the left over material and place in a holding bucket or bin. Repeat until you have harvested everything from your bin and proceed to the next screen size and so on…

The other nice feature is when I was done using the harvester; I simply pulled the rod out and wrapped all three screens around the five gallon can, placed back into the bin and placed my lid on top.  Everything but the rod can be stored within the worm harvesting bin

Bruce